Ditto X2 Looper
Software+ Show version history + Hide version history
Changes in version 1.2.00
Ditto X2 Looper Software Windows - Version 1.2.00 - 2.71 MBReleased: Monday, June 16, 2014
- additional support for 16 bit audio files (aiff and wav). For better compatibility with existing DAWs you will now find 2 additional 16 bit/ 44.1kHz audio files in the Ditto's track folder when storing your loops.
- level management for stored audio files. Exported Files will be normalized when exporting them to your computer to make it easier to edit them further in the DAW of your choice
- enhanced protection for buffer underuns. This is a new safety mechanism to deal with "bad blocks" of the flash RAM memory chips.
+ Installation - Installation
To install the software update proceed as follows:
Ditto X2 Looper Software Mac - Version 1.2.00 - 2.06 MBReleased: Monday, June 16, 2014
- download the Ditto X2 firmware update installer for your operating system from the Tc electronic website and store it on your computer's harddisk
- connect your Ditto X2 with an USB cable to your computer
- get your Ditto X2 into Boot mode by inserting the power jack while holding down the Loop switch (the Loop switch LED will turn green indicating that your pedal is ready for software upload)
- open the installer and select your X2 from the output device
dropdown menu as seen in the screenshot below (note: If you are
using Windows XP your X2 will be listed as "usb audio
press the (green) update button to start the firmware upload and wait until the progress bar has reached 100%.
your pedal will then automatically reboot and is ready to use.
Ditto X2 Looper
FAQ Knowledge Base articles
- Ditto X2: Battery life
- Ditto X2: Power requirements
- Ditto X2: Recording modes
- Ditto X2: Double time & reverse
- Ditto X2: Non-standard MP3s
- Ditto X2: USB Disk Mode
- Ditto X2: Track folder is empty
- Ditto X2: Requirements for external power supply
- Ditto X2: Setting the backing track level
- Ditto X2: Clearing loop without triggering playback